Overview

Introducing Suregrip® Aqua, the next generation of anti-slip floor coatings. Building on the trusted performance of the original Suregrip®, this innovative water-based formula offers the same exceptional slip resistance and durability now with the added benefits of quick-drying, low-odor, and low-VOC emissions for a cleaner, greener application.

Perfect for environments where both safety and efficiency are paramount, Suregrip® Aqua delivers a tough, high-performance finish designed to reduce environmental impact without compromising on protection. Whether indoors or out, in wet or dry conditions, it provides a secure, reliable surface that keeps people safe in even the most demanding areas.

• Pre-Aggregated finish
• Ideal for ramps, stairwells, playgrounds, parks, warehouses and industrial spaces
• Suitable for foot and light vehicle traffic
• Ideal for areas prone to moisture or spills

Preparation

Proper surface preparation is essential to ensure maximum adhesion and durability of Coo-Var Suregrip® Aqua. Follow the guidelines below based on the type of surface:

General Preparation (All Surfaces)

• Ensure surfaces are clean, dry, sound, and free from dust, oil, grease, loose material, and other contaminants.
• Remove existing coatings that are flaking or peeling.
• Always degrease with an appropriate degreaser before sanding or priming.

Concrete Surfaces

• Power-floated, granolithic, or smooth concrete must be roughened to provide a proper "key" for adhesion.
• Mechanical: Abrading or blasting.
• Chemical: Use Coo-Var Acid Etch (This also removes dirt and laitance from the surface.)
• New concrete should be fully cured before application.
• Priming: Apply a coat of Coo-Var Acrylic Floor Paint thinned 5% with water to seal and prime the surface before applying Suregrip® Aqua.

Metal Surfaces

• Clean and degrease thoroughly.
• Prime with: Coo-Var Zinc Phosphate Primer

Wood Surfaces

• Clean and degrease to remove all contaminants.
• Prime with: Coo-Var Aluminium Wood Primer or Coo-Var Acrylic Floor Paint (thinned 5% if used as a sealer)

Previously Painted Surfaces

• Clean, degrease, and lightly sand to ensure a good key.
• Remove all loose or flaking paint.
• Treat any bare areas as new substrate and prepare accordingly with the correct primer.

Following these preparation steps will ensure the best performance and longevity of Coo-Var Suregrip® Aqua.

Application

To achieve the best performance and finish from Coo-Var Suregrip® Aqua, follow these detailed application guidelines:

• Mix thoroughly before and during use to ensure an even distribution of texture and pigment.
• Ensure the surface has been properly prepared and primed with the appropriate Coo-Var primer for the substrate.
• Only apply when ambient and surface temperatures are above 7°C during both application and drying.
• Provide adequate ventilation, especially in confined or enclosed spaces.
• Use a short pile roller sleeve for even texture and optimal coverage. Brush application is suitable for edges and hard-to-reach areas.
• Apply a minimum of two coats of Suregrip® Aqua for a durable, anti-slip finish.
• Allow each coat to dry fully before applying the next.
• Avoid overworking the product once applied to maintain an even anti-slip texture.
• Ensure proper air flow during drying to promote proper curing.

Proper application is key to maximizing the safety and longevity of your surface.